Kenyan network installers should begin with the actual mating interfaces and site fiber records before assigning this product to a link. This one-push cleaner is developed for MMC-12 and MMC-24 connector end faces, covering APC, PC and UPC polish types. The disposable push-style tool advances dry cleaning material with each operation and is rated for at least 525 uses. It supports routine ferrule upkeep for multi-fiber panels, cable assemblies and test setups without liquid cleaner or replacement cartridges.
Product Highlights
- Cleaner Brand: US Conec IBC™
- Style: Push Style Port Cleaner
- Connector Type: MMC-12/24
- Polish Type: PC/UPC/APC
- Number of times: ≥ 525 times
- Use Type: Disposable
Specifications
| Part Number | 25802 |
|---|---|
| Manufacturer | HT |
| Cleaner Brand | US Conec IBC™ |
| Style | Push Style Port Cleaner |
| Connector Type | MMC-12/24 |
| Polish Type | PC/UPC/APC |
| Number of times | ≥ 525 times |
| Use Type | Disposable |
One tool for MMC-12 and MMC-24 interfaces
The cleaning tool addresses the specified MMC-12/24 connector formats, not the MMC-16 variant covered by the independent tool. Check the optical connector variant before use, especially in a panel containing various MMC variants. Correct cleaning removes dust and light contamination that can raise insertion loss or damage ferrules when connectors are mated under pressure.
Cleaning before inspection and mating
Align the cleaning tool squarely with the port or connector and full one firm push cycle. Then check the end face rather than assuming it is clean. If contamination remains, adhere to the connected equipment-compatible cleaning method and avoid improvising with unapproved swabs or solvents. Clean the mating connector as well, or debris can transfer back to the first ferrule.
Maintaining a reliable field tool
Keep the cap fitted during storage and replace the disposable unit after its rated uses. Never disassemble the advance mechanism or use the cleaning tool on live optical interfaces. Technical staff should disable sources, check with a suitable microscope and dust-cap clean connectors until they are ready to be mated.
Ordering and Factory Support
Use part number 25802 for the MMC-12/24 cleaner and identify number of units. If your toolkit further services MMC-16 connectors, list the independent MMC-16 cleaner in the order and label the two tools for quick identification. Project support for Kenya and East Africa is available to reconcile the ordered configuration with the intended installation.